Autodesk Design Suite 3D - Planix Home Design Suite 3D Manuale di Servizio Scaricare il pdf (Pagina 98)

Using Drafting Settings

To use AutoTrack for object snap tracking

Steps

Use

to look up

Start by drawing a line or polyline in your drawing,

such as the line shown here.

You will use AutoTrack to draw another line based

on the snap points of this line.

Turn on a running object snap like ENDPOINT by

using the Drafting Settings command on the Tools

menu.

Turn on AutoTrack by depressing the OTRACK

button on the Status Bar.

Using AutoTrack

Run a drawing command, like LINE.

When you are prompted to select a point, hold

your cursor over one end point on the original line

you drew in step 1, but do not click.

A small plus sign (+) is displayed over the point.

Move your cursor to a second end point on the

original line you drew in step 1, but do not click.

A small plus sign (+) is displayed over the second

point.

Move your cursor to locate an alignment point, as

shown in the following illustration:

Click to place the start point of the line at this

location that AutoTrack identified.

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 284 285

Nessun commento

Autodesk Design Suite 3D - Planix Home Design Suite 3D Manuale di Servizio Pagina 98